4400 Sterilite Drive
Ennis, TX 75119 · Iko Metals Usa Inc.
IKO Metals factory modifications in Ennis
Modifications to the IKO Metals factory at 4400 Sterilite Drive include concrete work for process equipment, an office and breakroom area, new doorways and driveways, and structural steel for process components. The project was registered with TDLR on February 29, 2024, with about 43,000 square feet of work area; its estimated cost was $2.8 million.
Summarized from Texas Department of Licensing and Regulation records · updated Feb 29, 2024
- Projects
- 1
- 1 filings
- Latest filing
- Feb 29, 2024
- since Feb 29, 2024
- Largest scope
- 43,000 sf
- Estimated cost
- $2.8M
- state registration
Where this project stands
Inspected · closing outModifications to IKO Metals Ennis factory building
43,000 sq ft · $2.8M est.
- RegisteredFeb 29, 2024
- Plan review
- ConstructionMar '24 – Aug '24
- Inspected
- Closednow
The building is substantially done. Move-in, fit-out and service work usually follow.
4 contacts on this project · 2 phone numbers
Permit & project history
1 projectModification of concrete for process equipment, installation of office/breakroom area, new doorways & driveways, and structural steel for process components. approx. 43,000 sq ft of total work area. — iko metals ennis
TDLR project registrationRenovation/AlterationInspection Complete43,000 sq ft$2.8M est.- Project #
- TABS2024012689
- Tenant / owner
- Modifications To Iko Metals Ennis Factory Building
- Design firm
- Pro
- Contact
- Pro
Sources: Texas Department of Licensing and Regulation
Questions about 4400 Sterilite Drive
What is being built at 4400 Sterilite Drive in Ennis?
The project is a modification of the IKO Metals factory, including concrete for process equipment, an office and breakroom area, new doorways and driveways, and structural steel for process components.
Is a new factory being built at 4400 Sterilite Drive?
The TDLR registration describes modifications to the IKO Metals factory building, not a new factory.
When was the IKO Metals factory project registered?
The project was registered with the Texas Department of Licensing and Regulation on February 29, 2024. Its TDLR project number is TABS2024012689.
How large is the IKO Metals factory modification project?
The registration lists approximately 43,000 square feet of total work area.
How much will the IKO Metals factory modifications cost?
The TDLR registration lists an estimated project cost of $2.8 million.
Are the IKO Metals factory modifications complete?
The TDLR record lists the project status as Inspection Complete.