New new homes in Dallas 75223
37 addresses in 75223 have permits or project filings for new homes in the last two years. The most recent was filed at 1613 Caldwell Ave.
Latest filings
- 1613 Caldwell AveNov 12, 2026Plumbing associated with permit #res-new-26-001985
- 3203 Reynolds AveNov 10, 2026Nsfaa-bathroom addition
- 4515 Philip AveNov 4, 2026Install electrical for new construction
- 3330 Beall StOct 29, 2026Nsfaa-single family home - 3 bedrooms, 2 bathrooms
- 4617 Owenwood AveSep 10, 2026Nsfaa- this project is a new construction single family house with outdoor porch
- 6818 Hammond AveSep 8, 2026Install new 3.5-ton gas unit complete with ductwork
- 1423 Rowan AveAug 20, 2026Construct a new residential fence in the side and rear yards, starting exactly at the line of the front facade of the house (not invading the setback of the front yard). the style is board-on-board with a top cap. the top of the fence will remain horizontally leveled; due to the natural descending slope of the terrain, the height will vary from 6.5 to 7.5 feet in height at the starting point, reaching a maximum of 9.0 feet in height in the backyard. the total height remains strictly within the residential limit of 9 feet of the city
- 4811 Sapphire StAug 11, 2026New plumbing, two bathrooms, kitchen, laundry
- 502 S Glasgow DrJul 17, 2026New wire for house 200 amp service
- 419 Cristler AveJul 17, 20268 1/2' wood fence on steel posts
- 412 Cristler AveJul 13, 2026Install new hvac for entire house
- 5237 Terry StJul 10, 2026We would like to build an 8 foot board on board pre stained cedar wood fence. it will consist of 242 feet of linear. 5237-5239 terry street
- 1323 Fairview AveJul 10, 2026New residential hvac installation
- 519 Newell AveJun 16, 2026Remodel , 3 wc, 3 lav, 3 shower, kit sk, wh elec, washer connection
- 4937 Lindsley AveJun 9, 2026Demolish approx. 1200 sq ft single family home sitting on slab
- 3201 S Haskell AveJun 6, 2026Install 1 5ton gas heat hvac system for 1st floor 1 4ton gas heat hvac system for 2nd floor and 1.5ton gas heat hvac system for 3rd floor all ductwork exhaust fans, vent-a-hood, and dryer vent
- 4942 Terry StJun 5, 2026We are pleased to provide the necessary manpower and equipment for the demolition permit.the project involves the careful demolition of approximately 1,200 single-family homes. all work will be conducted manually to ensure the protection of the wood slab. this process will include the removal of all roofing and side walls, leaving only the slab intact.please note that the removal is strictly confined to the property lines of the project site.legal disposal of all debris materials will be conducted by transporting all waste to the designated dumpster for proper disposal at the landfill
- 5102 Philip AveMay 18, 20268ft fence with wood pickets and wood post on a new construction duplex. 2 pedestrian 8ft gates total
- 1542 Caldwell AveMay 16, 2026Fence 8 foot high on right corner at my home
- 5319 Gurley AveApr 23, 2026New 3.5 tons electric system and air ducts
- 404 Cameron AveApr 6, 2026Install 2 hvac split “gas” systems, ductwork, exhaust fans and drain lines
- 4807 Sapphire StMar 20, 2026Install 2-ton hvac system, 2- exhaust fan, 1 dryer vent
- 7129 Granada PlMar 19, 20267129 granada - new single family residential
- 5409 Garland AveMar 9, 2026New wiring for new construction home
- 906 Cristler AveMar 5, 20268 1/2' wood fence on steel posts
- 419 Cameron AveMar 5, 20268 1/2' wood fence on steel posts
- 5023 Garland AveJan 20, 2026New home construction electrical
- 819 Clermont AveJan 16, 2026Install hvac
- 6939 Santa Monica DrDec 15, 2025Nsfaa remodel of existing kitchen and rear additionto single family dwelling
- 607 Grandview AveDec 9, 2025Install a new air conditioning and heating system with ductwork
- 1107 Mt Auburn AveDec 1, 20258 1/2' wood fence on steel posts
- 1541 Caldwell AveSep 28, 2025New hvac
- 1316 Fletcher StSep 14, 2025New hvac and ductwork duplex
- 3014 Reynolds AveAug 28, 2025Scope of work by construction phase:1. pre-construction planning & permitting• perform manual j load calculation for heating/cooling loads.• prepare manual d duct design for air distribution.• select hvac equipment per manual s sizing standards.• submit equipment specifications, cut sheets, and duct layout with permit package to city of dallas.• coordinate with builder/general contractor for mechanical chase, soffit, and utility penetration planning.2. rough-in stage (prior to insulation & drywall)• install all supply and return ductwork (r-8 insulated flexible duct for unconditioned spaces, per dallas/).• install sheet metal trunk lines, plenums, and boots per manual d layout.• install refrigerant line sets between indoor air handler/coil and outdoor condensing unit.• run condensate drain lines to approved termination points (with primary & secondary drains per imc §307).• install bathroom exhaust fans, kitchen vent ductwork, and dryer vent duct with exterior termination.• frame and set hvac platform (attic or mechanical closet as per plans).• install combustion air ducts (if gas furnace is used).• install venting for furnaces and water heaters (category iv pvc or b-vent, as applicable).• install gas piping to furnace (if applicable) with sediment traps, shutoff valve, and pressure test per ifgc.• provide fresh air intake/mechanical ventilation system in compliance with dallas energy code.• seal all ductwork connections with mastic or ul-listed tape (per ).3. equipment installation• install air handler/furnace unit in attic or mechanical closet.• install outdoor condensing unit on approved pad or platform, meeting dallas setback and clearance requirements.• connect refrigerant lines, pressure test, and evacuate system prior to charging.• install line-set insulation with uv protection where exposed.• connect electrical whips, disconnects, breakers, and thermostat wiring per nec.• connect gas piping (if applicable), perform pressure test, and verify for leaks.• set and level drain pans with float switches and secondary drains.• install supply registers, return grilles, exhaust grilles in planned locations.________________________________________4. trim-out & final connections• install programmable thermostat(s) per requirements.• install final supply/return registers and grilles.• install bath exhaust fan trim kits and kitchen vent termination hood.• seal penetrations at ceiling/walls for air barrier integrity.• charge refrigerant system per manufacturer specs and dallas code requirements.• balance air distribution system to provide correct airflow to each room.• verify combustion air and venting operation (if gas furnace).• test condensate drains for proper slope and drainage.________________________________________5. testing, commissioning & final inspection• perform duct leakage testing per (? 4 cfm/100 sq ft at 25 pa).• perform airflow balancing for proper cfm per room.• test gas piping and connections for leaks.• verify thermostat and system operational controls.• provide manufacturer startup sheets, equipment model/serials, and balancing report to homeowner and inspector.• schedule city of dallas final inspection for mechanical systems.________________________________________owner-supplied vs. contractor-supplied• contractor will provide and install all hvac equipment, ductwork, registers, grills, refrigerant piping, gas piping, and associated materials unless otherwise noted.• builder/homeowner to coordinate mechanical chase framing and access to electrical service.exclusions• removal of asbestos or hazardous materials.• structural modifications not shown in hvac plans.• utility company fees for gas or electrical service upgrades
- 5103 Philip AveAug 21, 2025New single family dwelling with attached 2 car garage
- 1322 Fletcher StAug 17, 2025New hvac and ductwork
- 1030 Parkview AveAug 11, 20258' board on board fence on the back yard perimeter of the the single family new build home. will have a trim piece on top and stained. there is also a 4' board on board fence to match along the left (west) side of the front yard property to block the neighbors chain link fence
- 601 Valencia StJan 12, 2021Plumbing (pl) single family alteration
Questions
What new homes are being built in Dallas 75223?
37 addresses in 75223 have permits or project filings for new homes in the last two years. The most recent was filed at 1613 Caldwell Ave. Others include 3203 Reynolds Ave, 4515 Philip Ave, 3330 Beall St.
How can I find out when a new new home is permitted near me?
Watch your ZIP code or address on groundranger to get an email as soon as a new new home permit is filed.