17503 Woods Edge Dr
Dallas, TX 75287
Permits list a 26-kW generator and gas line
Dallas permits indicate a permanent 26-kW generator and two 200-amp transfer switches are being installed at 17503 Woods Edge Dr. The electrical permit was filed November 5, 2026, and a gas-line plumbing permit followed on November 13, 2026.
Summarized from City of Dallas records · updated Nov 13, 2026
- Projects
- 2
- 2 filings
- Latest filing
- Nov 13, 2026
- since Nov 13, 2026
- Largest scope
- —
- Listed value
- —
Permit & project history
2 projectsSources: City of Dallas
Questions about 17503 Woods Edge Dr
What work is permitted at 17503 Woods Edge Dr?
Dallas permits list installation of a permanent 26-kW generator, two 200-amp transfer switches, and a gas line.
Is a generator being installed at 17503 Woods Edge Dr?
Yes. Residential electrical permit RES-ELC-26-006854, filed November 5, 2026, lists a permanent 26-kW generator and two 200-amp transfer switches.
When was the generator permit filed?
The City of Dallas filed residential electrical permit RES-ELC-26-006854 on November 5, 2026.
Is a gas line being added at 17503 Woods Edge Dr?
A City of Dallas residential plumbing permit dated November 13, 2026, describes the work as “Gen gas line.”
What are the permit numbers for work at 17503 Woods Edge Dr?
The records list electrical permit RES-ELC-26-006854, filed November 5, 2026, and plumbing permit RES-PLM-26-012353, filed November 13, 2026.
Also being built nearby
All of 75287- 17507 Oak Mount PlMar 4, 2026Replace water heater · 16 m away
- 17515 Oak Mount PlDec 2, 2025Install 3 50-gal gas water heater 2 upstair middle closet and left closet 1 downstairs closet · 23 m away
- 17508 Oak Mount PlApr 20, 2026Reroof · 27 m away
- 17523 Oak Mount PlNov 7, 2025Tear off composition , install 30 felt & decra shake granite gray 50 yr · 42 m away
- 17531 Woods Edge DrJul 16, 2025Installed 50 gallon gas water heater in garage closet · 53 m away
- 17531 Oak Mount PlJun 8, 2026Replacing 4 ton furnace only · 61 m away
- 17532 Woods Edge DrSep 28, 2026Re-roof · 63 m away
- 17427 Woods Edge DrFeb 12, 2026Gas test & repair · 78 m away
- 17423 Woods Edge DrMay 11, 2026Replace 3 50 gallon gas water heaters, 1 located on first floor in garage, 2 in attic above first floor · 82 m away
- 17415 Woods Edge DrOct 27, 2026Install 50 gallon gas water heater in garage closet (swap out) · 90 m away
- 17504 Ivy Hill DrOct 22, 2025Electrical permit required to close primary record res-solar-25-000307 for residential solar/pv.electrical scope of work has already been reviewed and approved as part of primary record. mcr with battery design and installation of a grid-tied residential solar photovoltaic (pv) system with battery energy storage at 17504 ivy hill drive, dallas, tx 75287. the proposed system consists of 21 meyer burger black 390 w monocrystalline pv modules mounted on the existing pitched asphalt shingle roof using the snapnrack topspeed original racking system. the modules will be installed in one contiguous array on the south-west facing 1st-story roof slope of the attached garage, at a tilt matching the roof pitch of 33°. the pv modules will be electrically connected in series to form strings that feed into an eg4 flexboss 21 hybrid inverter, which will be coupled to an eg4 gridboss microgrid interconnect device and an eg4 powerpro indoor wall-mounted lithium-ion battery for on-site energy storage and backup capability. the system will be interconnected to the utility grid in compliance with nec article 705 for grid-interactive systems, but will not allow excess generation to be exported to the grid. the total system capacity is 8.19 kw dc (390 w × 21 modules). the inverter’s ac output will be connected to the home’s existing electrical service panel via a dedicated solar breaker in accordance with nec 690.64(b) and 705.12(b). conductor sizes, overcurrent protection, and disconnects are selected to meet nec requirements for ampacity and safety. structural loading calculations, based on the 2021 international building code (), asce 7-16, and local amendments, confirm that the added distributed load of 2.41 psf from the pv system is well within allowable limits for the existing roof structure. the snapnrack topspeed racking system is designed and installed per the manufacturer’s installation manual and will provide wind uplift resistance for a basic design wind speed of 106 mph (exposure category b) and a ground snow load of 10 psf. all equipment used in this installation is ul-listed and compliant with the most recent nec, , and city of dallas building and electrical codes. the system will include nec-compliant labeling and placards for rapid shutdown, pv source circuits, ac disconnects, and battery storage. this project will provide the homeowner with renewable energy generation, reduced utility bills, and battery backup capability for resiliency during power outages, while meeting all safety, structural, and code requirements for rooftop solar installations in the city of dallas · 105 m away
- 5603 Oak Falls CirJun 24, 2025Tub to shower conversion with new valve · 126 m away