17507 Oak Mount Pl
Dallas, TX 75287
Water heater replacement permitted at 17507 Oak Mount Pl
A residential permit to replace a water heater at 17507 Oak Mount Pl was filed with the City of Dallas on March 4, 2026. The record lists permit RES-PLM-26-002440 and does not provide a project value.
Summarized from City of Dallas records · updated Mar 4, 2026
- Projects
- 1
- 1 filings
- Latest filing
- Mar 4, 2026
- since Mar 4, 2026
- Largest scope
- —
- Listed value
- —
Permit & project history
1 projectSources: City of Dallas
Questions about 17507 Oak Mount Pl
What is being built at 17507 Oak Mount Pl?
The City of Dallas permit record describes a water heater replacement, not a new building. The permit is RES-PLM-26-002440.
When was the water heater permit filed at 17507 Oak Mount Pl?
The residential plumbing permit was filed on March 4, 2026.
Is a new home being built at 17507 Oak Mount Pl?
The available record is for replacing a water heater. It does not describe construction of a new home.
How much will the work at 17507 Oak Mount Pl cost?
The City of Dallas record does not list a project value.
What is permit RES-PLM-26-002440 for?
It is a City of Dallas residential plumbing permit for a water heater replacement at 17507 Oak Mount Pl, filed March 4, 2026.
Also being built nearby
All of 75287- 17508 Oak Mount PlApr 20, 2026Reroof · 13 m away
- 17503 Woods Edge DrNov 13, 2026Gen gas line · 16 m away
- 17515 Oak Mount PlDec 2, 2025Install 3 50-gal gas water heater 2 upstair middle closet and left closet 1 downstairs closet · 27 m away
- 17531 Woods Edge DrJul 16, 2025Installed 50 gallon gas water heater in garage closet · 41 m away
- 17523 Oak Mount PlNov 7, 2025Tear off composition , install 30 felt & decra shake granite gray 50 yr · 45 m away
- 17532 Woods Edge DrSep 28, 2026Re-roof · 49 m away
- 17531 Oak Mount PlJun 8, 2026Replacing 4 ton furnace only · 63 m away
- 17427 Woods Edge DrFeb 12, 2026Gas test & repair · 87 m away
- 17423 Woods Edge DrMay 11, 2026Replace 3 50 gallon gas water heaters, 1 located on first floor in garage, 2 in attic above first floor · 90 m away
- 17415 Woods Edge DrOct 27, 2026Install 50 gallon gas water heater in garage closet (swap out) · 98 m away
- 17504 Ivy Hill DrOct 22, 2025Electrical permit required to close primary record res-solar-25-000307 for residential solar/pv.electrical scope of work has already been reviewed and approved as part of primary record. mcr with battery design and installation of a grid-tied residential solar photovoltaic (pv) system with battery energy storage at 17504 ivy hill drive, dallas, tx 75287. the proposed system consists of 21 meyer burger black 390 w monocrystalline pv modules mounted on the existing pitched asphalt shingle roof using the snapnrack topspeed original racking system. the modules will be installed in one contiguous array on the south-west facing 1st-story roof slope of the attached garage, at a tilt matching the roof pitch of 33°. the pv modules will be electrically connected in series to form strings that feed into an eg4 flexboss 21 hybrid inverter, which will be coupled to an eg4 gridboss microgrid interconnect device and an eg4 powerpro indoor wall-mounted lithium-ion battery for on-site energy storage and backup capability. the system will be interconnected to the utility grid in compliance with nec article 705 for grid-interactive systems, but will not allow excess generation to be exported to the grid. the total system capacity is 8.19 kw dc (390 w × 21 modules). the inverter’s ac output will be connected to the home’s existing electrical service panel via a dedicated solar breaker in accordance with nec 690.64(b) and 705.12(b). conductor sizes, overcurrent protection, and disconnects are selected to meet nec requirements for ampacity and safety. structural loading calculations, based on the 2021 international building code (), asce 7-16, and local amendments, confirm that the added distributed load of 2.41 psf from the pv system is well within allowable limits for the existing roof structure. the snapnrack topspeed racking system is designed and installed per the manufacturer’s installation manual and will provide wind uplift resistance for a basic design wind speed of 106 mph (exposure category b) and a ground snow load of 10 psf. all equipment used in this installation is ul-listed and compliant with the most recent nec, , and city of dallas building and electrical codes. the system will include nec-compliant labeling and placards for rapid shutdown, pv source circuits, ac disconnects, and battery storage. this project will provide the homeowner with renewable energy generation, reduced utility bills, and battery backup capability for resiliency during power outages, while meeting all safety, structural, and code requirements for rooftop solar installations in the city of dallas · 118 m away
- 5611 Oak Falls CirJun 12, 2026Drain repair · 131 m away