17508 Oak Mount Pl
Dallas, TX 75287
Home plumbing work and reroof permitted at 17508 Oak Mount Pl
Permits indicate work on an existing home at 17508 Oak Mount Pl, including plumbing updates permitted December 15, 2025, and a reroof permitted April 20, 2026. The plumbing permit covers water heater and drain work, bathroom plumbing changes, and gas and washer connections.
Summarized from City of Dallas records · updated Apr 20, 2026
- Projects
- 2
- 2 filings
- Latest filing
- Apr 20, 2026
- since Dec 15, 2025
- Largest scope
- —
- Listed value
- —
Permit & project history
2 projectsResidential home- utility: replace water heater and drain stub outs for sink, replace washer box and run gas into new dryer box. add ref. box.- secondary bath: replace water & drain stub outs for 1 lavatory, water stub out for toilet. shower - move plumbing to adjacent wall, install new rough valve, shower head and handheld. new shower pan. drain stays in same location
Residential home- utility: replace water heater and drain stub outs for sink, replace washer box and run gas into new dryer box. add ref. box.- secondary bath: replace water & drain stub outs for 1 lavatory, water stub out for toilet. shower - move plumbing to adjacent wall, install new rough valve, shower head and handheld. new shower pan. drain stays in same location
City of Dallas permitResidential Plumbing Permit
Sources: City of Dallas
Questions about 17508 Oak Mount Pl
What is being built at 17508 Oak Mount Pl?
The records do not indicate a new building. They show residential plumbing work and a reroof at the existing home.
What work was permitted at 17508 Oak Mount Pl?
A December 15, 2025 plumbing permit covers water heater and drain work, bathroom plumbing changes, and gas and washer connections. A residential roofing permit for a reroof was filed April 20, 2026.
When was the plumbing work at 17508 Oak Mount Pl permitted?
The City of Dallas issued record RES-PLM-25-008878 on December 15, 2025, for residential plumbing work.
Was a new roof permitted at 17508 Oak Mount Pl?
A reroof was recorded in City of Dallas permit RES-ROOF-26-000559 on April 20, 2026.
Is a new home being built at 17508 Oak Mount Pl?
The records provided do not show a new home construction permit. They show plumbing work and a reroof at the residential address.
Also being built nearby
All of 75287- 17507 Oak Mount PlMar 4, 2026Replace water heater · 13 m away
- 17503 Woods Edge DrNov 13, 2026Gen gas line · 27 m away
- 17531 Woods Edge DrJul 16, 2025Installed 50 gallon gas water heater in garage closet · 29 m away
- 17515 Oak Mount PlDec 2, 2025Install 3 50-gal gas water heater 2 upstair middle closet and left closet 1 downstairs closet · 30 m away
- 17532 Woods Edge DrSep 28, 2026Re-roof · 36 m away
- 17523 Oak Mount PlNov 7, 2025Tear off composition , install 30 felt & decra shake granite gray 50 yr · 46 m away
- 17531 Oak Mount PlJun 8, 2026Replacing 4 ton furnace only · 61 m away
- 17427 Woods Edge DrFeb 12, 2026Gas test & repair · 99 m away
- 17423 Woods Edge DrMay 11, 2026Replace 3 50 gallon gas water heaters, 1 located on first floor in garage, 2 in attic above first floor · 102 m away
- 17415 Woods Edge DrOct 27, 2026Install 50 gallon gas water heater in garage closet (swap out) · 109 m away
- 17504 Ivy Hill DrOct 22, 2025Electrical permit required to close primary record res-solar-25-000307 for residential solar/pv.electrical scope of work has already been reviewed and approved as part of primary record. mcr with battery design and installation of a grid-tied residential solar photovoltaic (pv) system with battery energy storage at 17504 ivy hill drive, dallas, tx 75287. the proposed system consists of 21 meyer burger black 390 w monocrystalline pv modules mounted on the existing pitched asphalt shingle roof using the snapnrack topspeed original racking system. the modules will be installed in one contiguous array on the south-west facing 1st-story roof slope of the attached garage, at a tilt matching the roof pitch of 33°. the pv modules will be electrically connected in series to form strings that feed into an eg4 flexboss 21 hybrid inverter, which will be coupled to an eg4 gridboss microgrid interconnect device and an eg4 powerpro indoor wall-mounted lithium-ion battery for on-site energy storage and backup capability. the system will be interconnected to the utility grid in compliance with nec article 705 for grid-interactive systems, but will not allow excess generation to be exported to the grid. the total system capacity is 8.19 kw dc (390 w × 21 modules). the inverter’s ac output will be connected to the home’s existing electrical service panel via a dedicated solar breaker in accordance with nec 690.64(b) and 705.12(b). conductor sizes, overcurrent protection, and disconnects are selected to meet nec requirements for ampacity and safety. structural loading calculations, based on the 2021 international building code (), asce 7-16, and local amendments, confirm that the added distributed load of 2.41 psf from the pv system is well within allowable limits for the existing roof structure. the snapnrack topspeed racking system is designed and installed per the manufacturer’s installation manual and will provide wind uplift resistance for a basic design wind speed of 106 mph (exposure category b) and a ground snow load of 10 psf. all equipment used in this installation is ul-listed and compliant with the most recent nec, , and city of dallas building and electrical codes. the system will include nec-compliant labeling and placards for rapid shutdown, pv source circuits, ac disconnects, and battery storage. this project will provide the homeowner with renewable energy generation, reduced utility bills, and battery backup capability for resiliency during power outages, while meeting all safety, structural, and code requirements for rooftop solar installations in the city of dallas · 125 m away
- 5611 Oak Falls CirJun 12, 2026Drain repair · 141 m away